Low Pro Lift Assemble Instructions

Thank you for purchasing the Jr. Dragster Low Pro lift.
After removing the lift from the box
1.Lay out the pieces (fig1)
Fig 1

2. Slide the two bottom parts of the lift together (fig 2) put the 3/8 bolts thru the holes and then the lock washers and tighten the nuts.
Fig 2

3. Attach the lift arm to the bottom frame (fig 3) slide the ½” bolt thru and tighten do not over tighten this needs to raise up and down freely now Attach the lifting rod to the front lift arm (fig 3) put the ½ inch nut on and tighten
(Fig 3)

4. Lift the handle to raise the front lift arm now take the top rail (the one with the latch pin) and put on the left side (fig 4) after putting the bolt in lift the rear lift arm and put the bolt in tighten do the same on the right side.
Fig 4

5. Now with the lift in the open position take the gas springs with the cylinder side up and snap them on to the balls (fig 5)

6. Lift is now ready for use when you lower the lift you will have to pull down on the lift arm and then latch it (fig6) without the car on the lift it will take some effort to lower it. You may have to use the extension for this.

Fig 6